Fault Alarm Contact

The open circuit will form when the power failure or port link failure.

24V DC Buzzer

 

24V Battery

 

 

 

The fault alarm device will

send a warning signal t warn the user, ex: alarm sound or flash light.

2.2 Mounting Installation

This section describes how to install the Ethernet Switch and make connections to it. Please read the following topics and perform the procedures in the order being presented.

2.2.1 DIN-Rail mounting

The DIN-Rail is screwed on the industrial switch when out of factory. If the DIN-Rail is not screwed on the industrial switch, please see the following figure to screw the DIN-Rail on the switch. To hang the industrial switch, follow the below steps:

Step1: Insert the top of DIN-Rail into the track.