Channel 1-13 (Europe)

Associated Clients You may press “Show Active Clients” button to check the connected client information. After the button pressed, you will see the dialog box as below:

You may press “Refresh” to get the new client table or “Close” to close this dialog box.

MAC Address 1 ~6 If you want to bridge multiple WAP-4035 in this mode, you have to enter the MAC addresses of other WAP-4035 into the fields.

Set Security IF you want to enable security to protect your wireless connection. Please press “Set Security” button and refer to section “3.2.8 Security setting for bridge mode” to

configure the detail settings.

After configuration complete, please click “Apply” button to save the configuration. Then you will see a screen to prompt you the settings are save successfully. You may press “Continue” for configure other settings or “Apply” to restart WAP-4035 with new configuration.

3.2.7Universal Repeater Mode

This mode allows you to extend the range of your wireless network. When the AP is configured to repeater mode, it will repeat the wireless signal from wireless client to access point. Thus, the wireless connection distance can be extended. However, the performance will become half of normal performance when client connect to a Repeater. Besides, when the WAP-4035 is configured to repeater mode, you can only manage the AP through LAN interface and the PC(s) connected to its LAN port cannot communicate with other wireless clients.

20