![](/images/backgrounds/135197/135197-4024x1.png)
After configuration complete, please click “Apply” button to save the configuration. Then you will see a screen to prompt you the settings are save successfully. You may press “Continue” for configure other settings or “Apply” to restart
3.3Advanced Settings
You should not change these advanced parameters unless you know what effect the changes will have on this access point.
Parameter |
| Description |
| Open | Normally, you can leave this at “Auto”, so that Wireless Stations can use |
| System | either method ("Open System" or "Shared Key".). |
Authentication |
| If you wish to use a particular method, select the appropriate value - "Open |
Shared | ||
Type | Key: | System" or "Shared Key". All Wireless stations must then be set to use the |
|
| |
|
| same method. |
| Auto | |
|
| |
|
|
|
Fragment Threshold | “Fragment Threshold” specifies the maximum size of packet during the | |
|
| fragmentation of data to be transmitted. If you set this value too low, it will |
|
| result in bad performance. |
|
|
|
RTS Threshold |
| When the packet size is smaller than the RTS threshold, the access point will |
|
| not use the RTS/CTS mechanism to send this packet. |
|
|
|
Beacon Interval |
| The interval of time that this access point broadcast a beacon. Beacon is |
|
| used to synchronize the wireless network. |
|
|
|
Data Rate |
| The “Data Rate” is the rate this access point uses to transmit data packets. |
|
|
|
24