SETUP
1
To install base unit, first thread the USB cable through the bottom of the base so it rests in the notch. Then attach the stand by inserting the stand pegs into the holds on the underside of the base unit.
2
Connect USB connector to a free USB port on your computer. A USB hub can be used but ensure that it can supply sufficient power (250 mA) to charge the headset.
Alternatively, the velcro strips included can be used to attach the base unit to a PC monitor. However, if that causes noise or interference problems, see “Positioning” on page 7.
3
The optional AC charger can be used.
CHARGING
1 hour = minimum charge to continue setup
3 hours = full charge
1
2
1.Slide headset into charging cradle.
2.Gently press down on the headset to ensure that headset is in correct position. Red charge indicator light on base will illuminate while charging and will go off completely when fully charged.
AC charging only:
When your computer is powered off, the
USB charging only:
When your computer is powered on, the
POSITIONING
30CM
15cm6“
The minimum recommended separation distance is shown above.
IMPORTANT: Incorrect positioning can cause noise and interference.
6
7