Plantronics CS50, CS60 manual Subscription, Battery Replacement, System Reset

SUBSCRIPTION

The headset and base unit are supplied subscribed to each other. However, if you wish to use a replacement headset with the base unit, then the units must be re-subscribed as follows:

1 2 3

BATTERY REPLACEMENT

The custom battery inside the headset should last 2-3 years. When talk time decreases significantly, you should replace the battery. Call Plantronics at 0800 410 014 to order one. Once you have received it, follow directions below to replace.

1 2

Return the headset to the charging cradle.

1.Use a paperclip to press and hold the subscription button through the access hole on the base unit for a minimum of

5 seconds. The status indicator light will then flash.

2.Press and hold the headset mute switch for a minimum of 5 seconds. The headset indicator light will then illuminate.

Successful re-subscription is indicated when the status indicator is fully illuminated and the talk indicator light is off.

3.Disconnect the USB charger first, then the AC charger (if used) from the AC charging jack for 5 seconds.

4.Reconnect the USB charger first, then the AC charger (if used).

If re-subscription fails within 2 minutes, the headset will return to the un-subscribed state. Try the re-subscription process again or call Technical Support.

Pinch both sides of the battery cover and lift	Slide the battery out and gently separate
to remove.	at the connection. DO NOT pull the battery
	out by the wires.

SYSTEM RESET

To recover from some fault conditions (refer to Troubleshooting page), you may need to perform a system reset.

1 2 3

3 4

1.Press both the call control button and the listening volume/mute button for 5 seconds. When the talk indicator light blinks, release both buttons.

2.Press the call control button again. The talk indicator light will again blink briefly to indicate the headset is back to normal operation.

3.Disconnect the USB charger first, then the AC charger (if used) from the AC charging jack for 5 seconds.

4.Reconnect the USB charger first, then the AC charger (if used).

The system reset operation is complete.

Reconnect and install the new battery.	Pinch both sides of the battery cover
	and replace.

After replacing the battery, remember to allow 3 hours to fully charge.

18

190