ADJUSTING FIT
Retaining
Ring
Snap speaker into retaining ring of desired wearing option (headband or earloop).
2
1
1.Adjust headband to fit.
2.Rotate headset in retaining ring until microphone is pointing towards your chin.
MAKING/ANSWERING/ENDING CALLS
2
To make a call:
Press the call control button on the headset. The status indicator lights on both the base and the headset should go on, indicating a successful link. Dial using softphone.
To answer a call:
Press the call control button on the headset to answer a call. When the ringer switch on the side of the base is on (in the up position), the base will ring with an incoming call – so you can receive notification of a call even when not wearing the headset. The feature is disabled when the ringer switch is in the down position.
To end a call:
Press the call control button on the headset.
To switch between calls:
Some softphones support a feature known as “flash”. This allows you to place the current call on or off hold or to toggle between calls. To do so, rock the headset volume control either way for more than 2 seconds. See diagram under “Adjusting Volume, Initiating Flash” on page 12.
When using PerSono Suite, the radio link between the headset and the base will only be active during a call. This is the default setting intended to preserve the battery life of the headset. However, you may wish to have the radio link active when not on a call so you can listen to other audio sources, such as streaming audio on your PC. You can open the radio link at any time by pressing the call control button on the headset.
NOTE: Locking the radio link on for extended periods of time will significantly reduce the standby and talk time of the headset.
For softphones not compatible with PerSono Suite
Check the PerSono Suite compatibility list at www.plantronics.com/SoftphoneCompatibility for the most current information on softphone compatibility.
If your softphone is not currently supported by PerSono Suite, remote detection and answer/end via the headset does not function. Pressing the call control button on the headset will only open and close the radio link providing audio; you must answer the call from the softphone.
10
11
