User Manual
Notes:
If you need to use the emergency eject pinhole, make sure that the unit is powered off and that the disk has stopped its rotation
If the SCSI ID is changed with the unit powered ON, then power must be removed and reapplied for the new ID to take effect.
Before moving the drive, always ensure that the optical disk cartridge is removed.
The drive has various functions that may be altered from their defaults if required. These are outlined in the MOD910I section. Opening the enclosure and changing these settings must only be carried out by a qualified service engineer.
Internal Drive
!The internal drive can be used in both the vertical and horizontal plane.
!The external drive must only be used in the horizontal plane.
•Attaching screws are supplied with the unit. The screws are M3 x
8 mm, and the fixing plate should be within the range of 1.5 to 2.5 mm, which includes the washer.
•Included with internal drives is a
Note for correct orientation of the flat cable when installing! Pin 1 is usually identified by a red stripe on the edge of the cable, and connectors have a small arrow by pin 1.
!Connect the internal power connector in your computer to the drive making sure that the orientation is correct.
97705183 A | 9 |
|
|
