I M P O R T A N T S A F E T Y I N F O R M A T I O N
Precautions
Please read this man ual carefully before using y our PLUS
Your serial number is located next to the main power switch on the back of your
CAUTION
TO PREVENT SHOCK, DO NOT OPEN THE CABINET. NO
WARNING
TO PREVENT FIRE OR SHOCK, DO NOT EX- POSE THIS UNIT TO RAIN OR MOISTURE. DO NOT USE THIS UNIT’S GROUNDED PLUG WITH AN EXTENSION CORD OR IN AN OUT- LET UNLESS ALL THREE PRONGS CAN BE FULLY INSERTED. DO NOT OPEN THE CABI- NET. THERE ARE
DOC Compliance Notice
This Class A digital apparatus meets all requirements of the Cana- dian
RF Interference
WARNING
The Federal Communications Commission does not allow any modifications or changes to the unit EXCEPT those specified by PLUS Technologies in this manual. Failure to comply with this government regulation could void your right to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide rea- sonable protection against harmful interference in a com- mercial installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harm- ful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their own expense.
Important Safeguards
These safety instructions are to ensure the long life of your Data projector and to prevent fire and shock. Please read them carefully and heed all warnings.
Installation
•For best results, use your Data projector in a darkened room.
•Place the projector on a flat, level surface in a dry area away from dust and moisture.
•Do not place your Data projector in direct sunlight, near heaters or heat radiating appliances.
•Exposure to direct sunlight, smoke or steam can harm internal components.
•Handle your Data projector carefully. Dropping or jarring can damage internal components.
•Do not place heavy objects on top of the Data projector.
•If installing the Data projector in the ceiling:
–The ceiling must be strong enough to support the Data projec- tor and the installation must be in accordance with any local building codes.
–The Data projector must be installed by qualified PLUS ser- vice personnel.
Power Supply
•The Data projector is designed to operate on a power supply of 100 to 120 or 220 to 240 V 50/60 Hz AC. Ensure that your power supply fits this requirement before attempting to use your Data projector.
•Handle the power cable carefully and avoid excessive bending. A damaged cord can cause electric shock or fire.
•If the Data projector is not to be used for an extended period of time, disconnect the plug from the power outlet.
Cleaning
•Unplug the Data projector before cleaning.
•Clean the cabinet periodically with a damp cloth. If heavily soiled, use a mild detergent. Never use strong detergents or solvents such as alcohol or thinner.
•Use a blower or lens paper to clean the lens, and be careful not to scratch or mar the lens.
E – 2
