Preparing the Remote Control
Button Battery Replacement
Using the remote control for the first time
The battery compartment is fitted with a transportation insulation sheet at the time of shipping. Pull out the sheet and remove it. The remote control is now ready for use.
Replacement Method
1 Insert the tip of a ballpoint pen or some other pointed object into the hole of the battery holder, then pull out to open.
2 Remove the old battery and in- stall a new button battery with (+) side facing upward in the battery holder.
3 Insert the battery holder into the re- mote control and push in until the battery holder closes with a "click" sound.
|
| H | |
|
|
| N |
|
|
| A |
n | CR20253V | P | |
A | |||
|
|
| J |
M |
| OL | T S |
|
| ||
|
| ||
CR2025
Purchase a CR2025 type battery for replacement.
|
| H |
|
| N |
|
| A |
n | P | |
CR20253V | ||
|
| A |
|
| J |
M |
| S |
| O | |
| ||
|
| CR2025 |
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type (CR2025) recommended by the manufacturer. Dispose of used batteries according to your local regulations.
Remote Control Range
Point the infrared transmitter of the remote control toward the remote control sensor located at the front or rear of the main unit and operate.
Reception of the remote control signal should generally be possible within the range illustrated below.
ACCESS Indicator
30˚
30˚
5m / 16.4 feet
20˚
Top View
Remote con- trol sensor
Remote con- trol sensor
Remote control in- frared transmitter
7m / 23 feet
20˚
| Remote control in- |
Side View | frared transmitter |
Function of the ACCESS Indicator
When the projector's remote control sensor receives the remote control signal, the ACCESS indicator flashes once and the projector begins operation. If the indicator does not flash, check the following points.
•The indicator will not flash when bright light strikes the projector's remote control sensor or the remote control's transmitter, or when there is an obstacle located in between that blocks the signal.
•The indicator will not flash when the button battery is exhausted.
| SELECT |
ENTER | CANCEL |
ACCESS
