Operation with the Remote Control
Point the remote control toward the remote control sensor of the main unit and operate.
ASPECT button
This button selects the vertical and horizontal ratio of the screen of the input video.
These buttons are used for the selection of the input signal.
For further information about input selection. VIDEO button
This switches the input to the VIDEO signal.
This switches the input to the
This switches the input to the Y Cb Cr signal. DVI button
This switches the input to the
ON/STANDBY
ASPECT
VIDEO
MENU
SET
ESC
ON/STANDBY button
This button is used to switch ON the power and set the unit to the STANDBY mode.
These buttons are used for menu opera- tions.
→Page
MENU button
This is used in the selection of the menu name when displaying the menu on the projection screen.
ESC button
This is used when closing the menu.
SET button
This is used to set the menu items.
Cursor buttons (← → ↑ ↓ )
These are used in the selection of the menu name, item name, and contents.
Turning ON Power/STANDBY
Press the POWER button of the main unit and turn on the main power.
To turn on the power:
Check that the POWER/ indicator of the main unit is lit or- ange.
Press the ON/STANDBY button for about 2 seconds.
ON/STANDBY
The power will be switched on, the indicator will flash green (for one minute) and then the indicator will be lit green. The projec- tion screen will brighten in about 40 seconds.
Light in green
POWER/ STATUS
Power ON
Note: To save electrical power when not using the unit, switch off the main power. When doing so, wait until the flashing orange indicator is lit steadily.
Setting standby mode:
Press and hold down the ON/STANDBY button for about 2 sec- onds.
The indicator will flash orange (for 60 seconds) and then be lit orange.
Light in orange
POWER/ STATUS
Standby
Attention!
When switching off the main power or disconnecting the power cord
First press ON/STANDBY button of the remote control or the main unit to set the standby mode (in which the indicator will be lit orange) and then switch off the main power. If the main power of the main unit is switched off without setting the standby mode, this could shorten the life of the lamp or possibly cause damage due to the heat of the lamp.
E – 22