18
M4 x 8 flat head screws
Hanger bracket
Hook
M4 x 6 screws
Partition panel
Hooks
(3) Mount the hanger brackets to the screw holes at the
middle of the partition hangers (left and right).
• Use the M4 flat head screws.
• The partition hangers have screw holes for mounting hanger
brackets at both the top and middle. Use the top holes when
mounting the copyboard on a tall panel.
(4) Mount the hooks (2) to the tops of the hanger brack-
ets using M4 x 6 screws (2 each).
•First fasten the hooks loosely to the maximum width of 60 mm
to make it easier to hang the copyboard on the panel.
•The hanger brackets can be used for panels of 50 to 60 mm
thickness.
(5) Mount the copyboard on the partition
panel.
Catch the hooks onto partition panel.
Take the panel in the hooks so as to fit snugly to
the thickness then fully tighten the hooks’ screws.
WARNING
• The copyboard sits freely on the partition, it is not fixed to it. Do not push the copyboard upwards or otherwise
lift it. Doing so may cause it to come off the partition and drop.
CAUTION• If the partition panel is not stable, take the necessary measures to keep it from tipping over, by for example
fastening its feet or struts to the floor, etc.
Tall panel mount position
Hanger bracket
M4 x 8 flat head screws