20
Names of Main Unit Controls and Connectors
MEMORY
POWER
CLEAR
POSITION
FEED
/STOP
MEMORY
POWER
CLEAR
POSITION
FEED
/STOP

햻

햺

햸

햵

햴

햶

햳

햲

햷

햹

The connectors are located
on the bottom side of the
copyboard.
When set vertically
The connectors are
located on the left side
of the copyboard.
햲POWER button
Use this to turn the power on and off.
햳POWER indicator (Green)
This lights when the power is turned on and turns off
when the power is turned off. The indicator flashes to
indicate errors or the operating status.
햴MEMORY button
Use this to save drawings, words, etc., you have drawn
or written on the sheet surface into the memory.
햵MEMORY indicator (Amber)
This blinks when the data is being stored in the
memory. Depending on the speed at which it is blink-
ing, it may also indicate an error.
햶FEED/STOP button
Use this to automatically feed 1 sheet or to stop feed-
ing.
햷CLEAR button
Use this to clear all the image data in the built-in
memory (when pressed for at least 3 seconds).
햸Card slot
This card slot is exclusively for CF memory cards.
햹POSITION button
(pin hole – button is located at bottom of hole)
Use this to switch the image to be stored in the memory
between the vertical and horizontal mode.
햺DC power jack
Connect the DC side of the AC power adapter here.
(Never connect anything other than the dedicated AC
adapter.)
햻USB connector (type B)
Connect this to a computer’s USB port (type A).
Notice:

Indicator blinking frequencies and terms used in this manual

The blinking of the indicators is used to indicate both the copyboard’s operating status and errors. In this manual the

frequencies are expressed as shown below.

Terms in manual Blinking frequency Diagram of flashing
Blinking slowly Lit 0.5 seconds, off 0.5 seconds
Blinking quickly Lit 0.25 seconds, off 0.25 seconds
Blinking intermittently Lit 0.25 seconds, off 0.25 seconds,
lit 0.25 seconds, off 1.25 seconds
Error blinking
The (amber) Memory indicator and the (green)
Power indicator blink alternately at high rate.