General Operation
Using the Presentation Timer
The presentation is given while checking the timer displayed on the screen.
The gauge display allows the remaining time to be known at a glance.
(1)Press the TIMER button to show the settings display.
The display will close when an operation has not been made for about 10 seconds.
[Timer settings display]
Press the CANCEL button to close the display immediately.
(2)Use the and SELECT buttons to set the time.
The setting contents are “Off” and from 10 to 60 minutes (in
intervals)
Settings can also be made with the SELECT () buttons.
(3)Press the ENTER button and start the timer.
•The display of the timer setting will close, the display of the timer will appear and simultaneously the timer will start.
Gauge (Blue)
[Timer Display]
The blue gauge indicates the remaining time. When the gauge disappears,the time is up.
The gauge continues to be displayed when the timer is stopped. 
When the remaining time is “0”
(Gray)
•Press the ENTER button to restart the timer. The timer will start with the same time setting.
•Press the CANCEL button to close the timer display. The timer set- ting will return to “Off”.
Moving the Position of the Timer Display
The SELECT () buttons on the remote control permit movement within the movable range of the timer display.
STANDBYLASER
RGB VIDEO AUTO
MENUQUICK
Q
(2)
CANCEL button
ENTERCANCEL
(3)
FREEZE MUTE TIMER
(1)
12
VOL ZOOM
34
Movable Range of the Timer Display
Note:
*The timer display will be closed while the menu or the quick menu is displayed, and while a message is displayed; however, the timer will still be operating at such times. Also, the timer will not be displayed unless a signal is being input.
*While the presentation timer is being displayed, screen movement will not be possible in the zoom mode.
