PLUS Vision U7-132HSF General Operation, Input Selection, Automatic Adjustment of Analog RGB

General Operation

This section describes the use of direct operation with the main unit or remote control buttons.

For information about operation using the menu, see “Menu Operation Method” on Page E-27 and the various items on Pages E-44 to E-57.

Input Selection

Select the input signal to be projected. Press the SOURCE button on the projector or the RGB or VIDEO button on the remote control unit.

When one of the buttons is pressed, a menu for selecting the source ap- pears. Use the SELECT ￿ and ￿ buttons or the SOURCE, RGB and VIDEO buttons to select the desired source, then press the ENTER button.

When the “Auto Source” function is set to “On”, the input signals are searched for automatically in sequence, but the next input signal is not detected while the input signal selection menu is displayed.

SOURCE button

DVI → RGB → Image Viewer → Network → Video → S-Video U7-137SF only

RGB button

DVI → RGB → Image Viewer → Network

U7-137SF only

VIDEO button

Video → S-Video

Note

*When you do not operate source selection, the projector will assume the input selec- tion condition that was previously used.

*See “Auto Source” on Page E-51 for information about the Auto Source on and off conditions.

*When the input format has been switched, you may be required to reconnect the input signal.

SOURCEAUTO

MENU		QUICK
		MENU
STANDBY		LASER
RGB	VIDEO	AUTO
MENU		QUICK
		Q
ENTER		R-CLICK/
		CANCEL
FREEZE	MUTE	TIMER

12

VOL ZOOM

34

Automatic Adjustment of Analog RGB

This procedure automatically adjusts the position, screen size, vertical stripes and colors of the analog RGB or DVI analog input signals being projected.

Normally, this function is adjusted automatically at the time of signal selection.

Main unit operation/Remote control operation: Press the AUTO button. (This

will not function while the menu or the quick menu is displayed.) A press of the AUTO button starts the automatic adjustment.

Note

*If the display position is shifted, vertical lines appear on the picture, or the projection is not good even after using automatic adjustment, please perform image adjustment manually. See “Picture Adj. / Fine Picture / H Position / V Position” on Page E-44.

*If the position is off or there are dark vertical bands on the picture, press the AUTO button with the screen as bright as possible (make the screen as bright as possible by for example displaying the trash window over the entire screen). If the problem per- sists after pressing the AUTO button several times, set manually at the “Picture Ad- justment” menu.

*When the image extends beyond the boundaries of the screen or is smaller than the screen, set Aspect to “Auto”. See “Aspect” on Page E-49.

SOURCEAUTO

MENU		QUICK
		MENU
STANDBY		LASER
RGB	VIDEO	AUTO
MENU		QUICK
		Q
ENTER		R-CLICK/
		CANCEL
FREEZE	MUTE	TIMER

12

VOL ZOOM

34

E-27