Setup
Lamp Mode
Use this if the picture is projected on a small screen and the picture is too bright or when projecting images in dark rooms.
Select the item name “Lamp Mode” and select the setting contents with the SELECT () buttons.
Eco | The lamp brightness is set to 80% and the lamp life is extended. |
| (STATUS indicator is green) |
Normal | The lamp brightness is set to 100% and the screen is bright. |
| (STATUS indicator is off) |
Note:
Frequent switching this mode can degrade the lamp.
STATUS
STANDBY
STATUS Indicator
Input Format
This function is used in setting the input signals of the input connec- tors.
Normally, this should be set to Auto. When identification is not possible with Auto, make the setting.
Select the item name “Input Format”, press the ENTER button, and the sub menu will open.
Select the connector that is to be changed, and select the setting contents with the SELECT () buttons.
[DVI]
This is the signal setting for the DVI connector.
Auto | Automatically identifies the signal. |
RGB | Analog RGB signal is set. |
Digital | Digital RGB signal is set. |
Component . Component signal is set.
[RGB]
This is the signal setting for the RGB connector.
Auto | Automatically identifies the signal. |
RGB | Analog RGB signal is set. |
Component . Component signal is set.
(YPbPr and YCbCr signals are identified automatically.)
[Video] and [S-Video]
“Video” is the setting of the VIDEO connector’s color format,
Auto | Automatic identification. |
NTSC | Fixed to the NTSC system. |
NTSC 4.43 .. | Fixed to the NTSC 4.43 system. |
PAL | Fixed to the PAL system. |
PAL M | Fixed to the PAL M system. |
PAL N | Fixed to the PAL N system. |
PAL 60 | Fixed to the PAL 60 system. |
SECAM | Fixed to the SECAM system. |
Note:
*When the input format has been switched, you may be required to reconnect the input signal.
*The picture may be disturbed when the input format is switched or when the mode is set back to auto. This is not a malfunction. The picture will return to normal when the input is switched, etc.
