PLUS Vision U7-132HSF Preparing the Remote Control, Inserting the Batteries, Remote Control Range

Models: U7-132SF U7-132HSF U7-137SF

1 67
Download 67 pages 52.5 Kb
Page 12
Image 12

Preparing the Remote Control

Inserting the Batteries

When using the remote control for the first time, install the batteries that were supplied.

1 Slide the battery compartment cover (located on the bottom of the remote control) and pull off.

2 Insert the batteries to match the “+” and “–” as indicated in- side the compartment.

3 (A) Leaving a little space in the front, close the lid, (B) then with the back pressed tightly,

(C) press the lid towards the front.

(A)(C)

CAUTION

When replacing batteries, purchase two of the same type of AAA battery.

Heed the regulations in effect in your region on the disposal of spent batteries.

Remote Control Range

(B)

Point the infrared transmitter of the remote control toward the remote control sensor located at the front or rear of the main unit and operate.

Reception of the remote control signal should generally be possible within the range illustrated below.

Top View

Remote control sensor

40°

40°

Side View

Remote control infrared transmitter

Remote control infrared transmitter

40°

Remote control

 

sensor

40°

50°

 

30°

 

20°

 

10°

5m / 16.4 feet

7m / 16.4 feet

5m / 16.4 feet

7m / 16.4 feet

Note

*Exposure of the main unit’s remote control sensor or the remote control infrared transmitter to bright light or the obstruction of the signal by an obstacle located in the pathway may prevent operation.

*The remote control will not function when the battery is exhausted.

E-12

Page 12
Image 12
PLUS Vision U7-132HSF, U7-132SF, U7-137SF Preparing the Remote Control, Inserting the Batteries, Remote Control Range