Polaris D7500 manual Camera Handpiece Connection, Control Module Connection

INSTALLATION

Do not twist or turn the cable connectors. The Handpiece Cable connectors are keyed and mate straight on with the associated Camera Handpiece and Control Module connectors.

NOTE: In addition to the supplied 15-foot multi-conductor cable, optional 6, 9, 30 and 50-foot lengths are available from your authorized Air Techniques Dealer at an extra cost.

Camera Cable Connection - Carefully connect the supplied Camera Handpiece Cable between the Camera Handpiece and Control Module as follows:

Camera Handpiece Connection.

1..Using the gray molded connector cable end, align the connector key with the keyway of the Handpiece connector..

2..Insert straight into Handpiece connector until it securely snaps into place..

Control Module Connection

1..Using the 10-pin quick disconnect plug end, align connector key with the keyway of the mating CAMERA connector located on the front panel of the Control Module..

2..Insert the connector straight into the mating CAMERA connector until it securely snaps into place..

Camera

Handpiece

Polaris
	Connector
Handpiece	Key
Cable

Handpiece Cable

10-pin Quick

Disconnect Plug

Polaris Handpiece Holder with Chair-side Adapter - Installing the Chair-side Adapter is as easy as deciding on a location for maximum convenience and securing it to an empty customer-supplied standard Handpiece Holder. Refer to the illustration below and install the Chair-side Adapter as follows:

1..Insert Handpiece Holder Adapter (1) into the wide end of Grip (2)..

2..Press Grip (2) into the top of the chosen Handpiece Holder..

3..Insert Expander (3) into the bottom of Grip (2)

4..Insert and push the Joint Connector Hex Bolt (4) into Expander (3) engaging the thread of Handpiece Holder Adapter

(1) by turning the Joint Connector Hex Bolt (4) clockwise..

5..Using the supplied Short Arm Allen Wrench (5), tighten Joint Connector Hex Bolt (4) until the Chair-side Adapter is secure in the Handpiece Holder..

1

2

Customer-Supplied

Handpiece Holder and

Hanger Bar

3

1	Handpiece Holder Adapter	4
2	Grip
3	Expander
4	Joint Connector Hex Bolt	5
5	5/32 Short Arm Allen
	Wrench

Handpiece Holder Chair-side Adapter

Assembly

13