Polaris D7500 manual System Interconnections, Installation

SYSTEM INTERCONNECTIONS

Polaris System - The diagram below shows the possible interconnections for the Polaris System. The heavy solid connection lines designate the typical operating configuration (connected to a computer system). The dashed line shows the optional connection to a video monitor, while the lighter solid connection lines show camera and power connections common to all system setups. Connect the Polaris System as required by individual office equipment..

System Interconnection

Typical Connections

Optional Connections

Required Connections

ideo

Capture Card

POLARIS

15-Foot CAMERA

Handpiece HANDPIECE

Cable

POLARIS

CONTROL

MODULE

Note: S-Video and Composite Video cables can be connected to either a PC computer with capture card or video monitor as required by individual office equipment.

INSTALLATION

Installing the Polaris System is as simple as deciding where to place the Control Module and making the necessary cable connections to a video monitor and/or a PC loaded with an Air Techniques Authorized DirectX 9 compliant user-supplied streaming video software application such as Visix. Perform the following procedures to install the Polaris System.

Control Module Location - Locate the Polaris Control Module on a table top, cart or any flat stable surface convenient to an AC wall outlet and associated computer system/monitor. It can also be installed hanging under a table top, under the chair or on the computer using the supplied Dual Lock Fastener Kit. Make sure that the selected location allows easy access to front and rear panel controls and connectors..

12