TROUBLESHOOTING (continued)
Indicators Message
The POWER indicator, LAMP indicator and TEMP indicator light or blink in the following cases.
Table 1-9. Indicators Message list
POWER | LAMP | TEMP | Contents | |
indicator | indicator | indicator | ||
| ||||
|
|
|
| |
Lights | Turns off | Turns off | Standby status | |
orange | ||||
|
|
| ||
|
|
|
| |
Blinks | Turns off | Turns off | Warming up. Wait. | |
green | ||||
|
|
| ||
|
|
|
| |
Lights | Turns off | Turns off | Operation status. | |
green | ||||
|
|
| ||
|
|
|
| |
Blinks | Turns off | Turns off | Cool down. | |
orange | ||||
|
|
| ||
|
|
|
| |
|
|
| The lamp does not light. | |
Lights | Lights | Turns off | Wait some time (approx. 20 min.) before turning the | |
red | red |
| power on again. If the indicator still lights, the lamp may | |
|
|
| have failed and. Replace with a new lamp. | |
|
|
|
| |
|
|
| A lamp has not been inserted or the lamp cover is | |
|
|
| missing. | |
|
|
| Cut a power source, and happen for about 45 minutes, | |
Lights | Blinks | Turns off | and confirm the condition which a ramp and a ramp | |
red | red |
| cover mount this opportunity after cooling it fully. Make | |
|
|
| contact with the store when a power source is made ON | |
|
|
| again after the modification and it becomes the same | |
|
|
| display again. | |
|
|
|
| |
|
|
| The cooling fan is not operating. | |
|
|
| Cut a power source, and happen for about 20 minutes, | |
Lights |
| Blinks | and confirm this opportunity after cooling it whether a | |
Turns off | foreign substance isn't caught in the fan. Make contact | |||
red | red | |||
| with the store when a power source is made ON again | |||
|
|
| ||
|
|
| after the modification and it becomes the same display | |
|
|
| again. | |
|
|
|
| |
|
|
| Internal overheating. *1) | |
|
|
| Confirm this opportunity with the air filter if you don't | |
|
|
| become dirty or ambient air temperature doesn't exceed | |
Lights | Turns off | Lights | 35 degrees if intake mouth and an exhaust mouth aren't | |
red | red | occupied after cooling it cut a power source it happens | ||
| ||||
|
|
| for about 20 minutes. Make contact with the store when a | |
|
|
| power source is made ON again after the modification | |
|
|
| and it becomes the same display again. | |
|
|
|
|
*1) In some cases, when the air holes becomes blocked and the interior temperature rises, the lamp will be turned off for protection and the LAMP indicator will flash red. In such cases, turn off the MAIN POWER switch, allow the set to cool (for approx. 20 min.) and then turn the power on again.
