TROUBLESHOOTING (continued)
Symptom
Before requesting repair, check in accordance with the following chart. If the situation cannot be corrected, then contact your dealer.
Table 1-10. Symptom
Symptom | Possible cause | Remedy | Page |
|
|
|
|
The power is not | * main power switch is not | * Turn on the main power switch. |
|
turned on. |
|
| |
turned on. | * The power cord is | * Plug the power cord into an AC |
|
| disconnected. | power outlet. |
|
|
|
|
|
| * The input is not correctly set. | * Use the projector or remote control |
|
No video or audio. | * No signal input. | to set. |
|
| * Connect correctly. |
| |
|
|
|
|
| * The projector is not correctly | * Connect correctly. |
|
Video is present but | connected. | * Press VOLUME on the remote |
|
* The volume is seet to | control or display the menu screen |
| |
no audio. | minimum. | and adjust the volume. |
|
|
| ||
| * Mute is turned on. | * Press the MUTE button. |
|
|
|
|
|
| * The projector is not correctly | * Connect correctly. |
|
Audio is present but | connected. |
|
|
* The brightness adjustment | * Select BRIGHT with the MENU |
| |
no video. | knob is rotated fully clockwise. | button and the press the |
|
| * The slide lens door is still | button. |
|
| closed. | * Open the slide lens door. |
|
|
|
|
|
Colors are pale and | Color density and color |
|
|
color matching is | matching are not correctly | Adjust the video. |
|
poor. | adjusted. |
|
|
|
|
|
|
| * Brightness and contrast are | * Adjust the video. |
|
Images are dark. | not correctly adjusted. |
|
|
* The lamp is nearing the end of | * Replace with a new lamp. |
| |
|
| ||
| its service life. |
|
|
|
|
|
|
Video is blurred. | Focus or H PHASE is out of | Adjust the focus or H PHASE. |
|
adjustment. |
| ||
|
|
| |
|
|
|
|
The LAMP indicator | Lamp failure. | Wait approximately 20 min. and |
|
lights red. |
| then turn the power on again. |
|
|
|
|
|
|
| * Make sure the ventilation openings |
|
The TEMP indicator |
| are not blocked. |
|
Internal overheating. | * Clean the air filter. |
| |
lights red. |
| * Lower the ambient temperature to |
|
|
|
| |
|
| 35 degrees C or less. |
|
|
|
|
|
The LAMP indicator | * The lamp cover is not set | * Check and correct the setting of |
|
blinks red. | correctly. | lamp cover and lamp. |
|
* The lamp is not set correctly. |
| ||
|
|
| |
|
|
|
|
ENGLISH
