INSTALLATION
Installation of the Projector and Screen
Install the projector in a suitable environment according to instructions of the accompanying manual “SAFETY INSTRUCTIONS” and this manual.
Refer to the drawing and table below for determining of the screen size and projection distance.
a:Distance from the LCD projector to the screen. The projection distance shown in the table below are for full size (800 x 600 dots).
b:Distance from the lens center to the bottom of the screen (a, b:
Table 1-1. Installation Reference
|
|
| TOP VIEW | Screen size | a (inches) | b (inches) | ||
|
|
|
| (inches) | Min. | Max. | ||
|
|
|
|
| ||||
|
|
|
|
|
|
|
| |
|
|
|
| 40 | 37 | 46 | 3 | |
|
|
|
|
|
|
|
| |
|
|
|
| 60 | 57 | 69 | 5 | |
|
|
|
|
|
|
|
| |
|
|
|
| 80 | 77 | 93 | 7 | |
|
|
|
|
|
|
|
| |
|
|
|
| 100 | 96 | 116 | 9 | |
|
|
|
|
|
|
|
| |
|
|
|
| 120 | 116 | 139 | 10 | |
|
|
|
|
|
|
|
| |
b |
|
|
| 150 | 145 | 174 | 13 | |
|
|
|
|
|
|
| ||
a | SIDE VIEW | 200 | 194 | 233 | 17 | |||
|
| |||||||
|
|
|
|
|
| |||
|
|
|
|
|
| |||
Installation of liquid crystal projector
Please basically use liquid crystal projector at the horizontal position.
If you use liquid crystal projector by the lens up position, the lens down position and the side up position, this may cause the heat inside to build up and become the cause of damage.
Be especially careful not to install it with ventilation holes blocked.
Angle Adjustment
Use the foot adjuster on the bottom of the projector to adjust the projection angle. It is variable within 0˚ to 10˚ approximately.
ENGLISH
10°
Foot Adjuster | Press the foot adjuster button |
|
1.Lift up the front side of the projector.
2.Pressing the foot adjuster button, adjust the projection angle.
3.Release the button to lock at the angle to be fixed.
Horizontal inclination may be adjusted using the adjuster at the rear.
Do not release the foot adjuster button unless the projector is being held; otherwise, the projector could overturn or the fingers could get caught and cause personal injury.
