GETTING STARTED
Carton Contents
Your new Polk Audio Digital Solution system comes in six (6) cartons. If you do not have any of the pieces listed below, or if any component seems damaged, contact your Polk Audio retailer immediately.
Carton 1:
One (1) Preamp/Processor
One (1) Infrared remote control
Two (2) AA batteries for remote
Three (3) 20' (6M) speaker cables
Two (2) 40' (12M) speaker cables
One (1) 4 Meter
One (1) FM antenna wire
One (1) AM loop antenna
Carton 2:
One (1)
One (1)
Cartons 3 & 4:
One (1) EACH, RT800i loudspeaker
Four (4) carpet spikes and four (4) rubber feet per speaker
Carton 5:
One pair (2) f/x500i loudspeakers
Eight (8) adhesive rubber pads
Two (2) wall mounting screws
Template for wall mounting
Carton 6:
One (1) CS400i Center Channel Speaker
Four (4) adhesive rubber feet
Quick Start Guide (see illustrations on pages 8 and 9)
1.Remove all of the components and accessories from the shipping cartons.
2.Connect sources such as DVD player, VCR, etc. to the preamp/processor audio and video inputs using coaxial
3.Connect the video output of the
4.Connect the preamp/processor to the subwoofer with the supplied 4 meter
5.Using the supplied speaker wires, connect the speakers to the speaker terminals on the back of the subwoofer. Be sure to maintain correct polarity ( + to +, - to
6.Plug the AC cord that was in the subwoofer box into the AC receptacle on the subwoofer.
7.Plug the AC cords from the preamp/processor and subwoofer into 120V/60 Hz AC power outlets.
8.Turn the power switch on the subwoofer to the “Standby” position.
9.Press the power button on the preamp/processor front panel or remote control.
10.Select the input of your choice.
11.Set volume and bass level to taste and enjoy!
| BASIC SETUP |
6 | Polk Customer Service (800) |