Toshiba RAV-SM806BT-TR Outline of specifications, Remarks, “8. SETUP AT LOCAL, Site And Others”

No.	Item		Outline of specifications				Remarks
19	Save operation	1)	Turn on SAVE button on the remote controller.				Carry out setting
		2)	During operation of save operation,	lights on the			operation during stop of
			wired remote controller.				the unit; otherwise the
		3)	During save operation, the current release control is				unit stops operation.
							For the setup operation,
			performed with the restriction ratio set in EEPROM on
							refer to
			the outdoor unit.
							“How to set contents of
		4)	The restriction ratio can be set by keeping		SAVE	button
							save operation” in
			pushed for 4 seconds or more on the remote controller.
							Sction
		5)	When validating the save operation, the next operation
							“8. SETUP AT LOCAL
			starts with save operation valid because contents are				SITE AND OTHERS”.
			held even when operation stops, operation mode
			changes or power supply is reset.

6)The restriction ratio can be set by changing the setup data of CODE No. (DN) [C2] in the range of 50 to 100% (every 1%, Setting at shipment: 75%).

20 8°C heating/Frost	1)	This functional is intended for the cold latitudes and
protective operation		performs objective heating operation
		(8°C heating operation).	In a group connection,
	2)	This function is valid only for combination with the	if there is even one
		outdoor units.	combination with other
	3)	Using the indoor CODE No. [D1] (1 bit), Valid/Invalid of	unit, “This function is not
			provided.” is displayed.
		this function is set up at the customer’s side.

∗The setup by CODE No. is Invalid [0]/Valid [1] and Invalid [0] has been set at the shipment.

4)This operation is the heating operation which sets 8°C

as the setup temperature of the target.		The setup temperature
5) This function starts operation by pushing temperature		jumps from [18] to [8].
button	during heating operation; besides by
pushing	button for 4 seconds or more after
temperature reached the minimum set temperature.

6)To stop/release this operation, select and execute one from the following operations.

c Push button:

Heating operation 18°C setting) continues.

d Push [START/STOP] button: Air conditioner stops.

(Heating 18°C operation at the next start)

e Push MODE :

Other operation mode is selected and the operation continues.

7)As the setup temperature is 8°C and the human heating is not targeted, the cold air discharge preventive control (Item 7) is made invalid to suppress the intermittent operation.

8)The settings of the air direction and air volume are changeable during this operation.

9)The indoor fan stops to protect the compressor for 2 minutes after start of heating operation (Thermo-ON) by this function.

– 33 –