Toshiba RAV-SM806BT-E, RAV-SM406BT-TR Part name, Procedure, Remarks, Detachment, Attachment

No.	Part name		Procedure	Remarks
h	Fan motor,	1. Detachment
	Fan,	1)	Perform works until opening of the electric
	Fan case		parts box cover in works of 1 of f.	Fan motor wiring
		2)	Remove connectors for fan motor wiring	CN333
			from control P.C. board.	CN334

CN333 : Motor power supply (5P: White)

CN334 : Motor control (5P: White)

3)Open the fan case (under) and remove it while pressing claws of the fan case (under). (There are both sides of the case)

4) Remove the fixing screws (Ø5 x 10, 2 pcs.)	Fixing screw
of the fixing plate (2 pcs.) at the side of the
fan motor.

(The fan motor becomes temporal hanging status by fixing plate.)

5)While supporting the fan motor by hands, remove the fixing plate from the motor base to remove the fan motor.

6)Loosen the hexagonal screw hole of the fan and then pull out the fan from the shaft. (Hexagon wrench : 3mm)

2.Attachment

1)Insert the fan in the shaft while adjusting to match the hexagonal screw hole to the groove of the shaft.

2)Perform screwing the fan motor with the

fixing plate (Ø5 x 10, 2 pcs.) Fixing sheet metal

NOTE
Match the fan motor with turning direction of		Screw with
the fan and fix so that the 40 type and 80 type
		hexagonal hole
fan motor wirings are at refrigerant piping
side and 140 type is at opposite side of
refrigerant piping.
	140 Type
3) While positioning so that the fan is at the
center of the fan case (upper), fix the fan
with hexagonal screw.
NOTE	80 Type
Be sure to use a torque wrench for fixing and
tighten with 4.9N•m or more.
4) Attach the fan case (under) as original and
	40 Type		Refrigerant
check the fan turns smoothly without
coming to contact with the fan case.			pipng side

5)Connect the fan motor wirings as before, close and fix the electric parts box cover. Be sure to perform wirings as original in the electric parts box.

6)Attach air filter and suction panel as original position.

CAUTION

When replacing the fan motor, be sure to exchange the clamp filter with the fan motor lead wire.

– 86 –