Toshiba RAV-SM806BT-TR, RAV-SM406BT-TR Part name, Procedure, Remarks, Detachment, Attachment

No.	Part name		Procedure	Remarks
f	Electric parts	1. Detachment
	box		1) Perform works of 1 of c.
			(In case of under air intake)
			Perform works of 1 of d.
			(In case of back air intake)
			Perform works of 1 of e.
			2) Remove the indoor/outdoor connecting wire and
			remote controller wire from each terminal block.
			3) Remove the connectors which connected
			from the control P.C. board to other parts.
			NOTE
				Electric parts box
			First unlock the housing and then remove the
			connectors.
			CN34 : Float switch (3P, Red)
			CN41 : Remote controller terminal block (3P,
			Blue)
			(Screw part of terminal block, 2P.)
			CN504 : Drain pump (2P, White)
			CN67 : Power supply terminal block (5P: Black)
			(Screw part of terminal block, 3P.)
			CN101 : TC sensor (2P: Black)
			CN102 : TCJ sensor (2P, Red)
			CN104 : Room temperature (2P, Yellow)
			4) Remove screws. (Ø4 x 10, 2 pcs.)
			5) Slide the electric parts box toward the arrow
			mark and then remove the box from the	Screw	Notch part
			bottom side of the main unit.
		2. Attachment
			1) Attach the electric parts box and then perform
			wiring as original.
			Notes 1
			Check there is no missing or contact failure on
			the connectors.
			Notes 2
			Be sure to perform wiring as original.
			2) Attach air filter, suction panel, and electric
			parts box as original.
g	Control P.C.	1. Detachment
	board		1) Perform work of 1 of f.
			(In the works of 1 of f, removal of the
			control P.C. board is available even if you do
			not perform works after 4)).
			2) Unlock the card edge spacers (5 positions) in the
			electric parts box to remove the control P.C. board.
		2. Attachment
			1) Mount control P.C. board in the electric parts
			box as original.
			2) Attach the electric parts box as original.	CAUTION
			3) Be sure to perform wiring as original in the
			electric parts box.	When replacing PC. board,
				check no-mex paper is attached.
			NOTE
			Check there is no missing or contact failure on
			the connectors.
			4) Attach each air filter, suction panel or
			electric parts box cover as original.

– 85 –