5Tap “Volume Up” button on your TV’s remote control 4 - 8 times, once per second. Tap, do not hold.
LED
LEARN LED blinks with
each button press
VOL
LED
Volume Up button
LED blinks blue
6When the LEARN LED and the button (command) both blink blue, the command has been learned.
LED
LED blinks blue
VOL
Verify command works.
Repeat steps
Note: If your bar fails to learn certain IR remote codes, the power LED will blink red. Try erasing any previously programmed codes (see below) and carefully repeat steps
Code Erasing Procedure: If you have pro- grammed your SurroundBar to respond to
a remote control and you no longer want it to do so, erase the codes by pressing the LEARN key for about two seconds while the unit is in standby
mode (power LED will blink). You’ll know that previ- ously learned codes have been successfully erased when the POWER LED blinks red twice.
Note: This procedure removes ALL of your bar’s remote control programming. If you only need to change the programming for some of the bar buttons, follow the six steps in the sequence previ- ously described to redo any previous programming.
The SurroundBar will continue to respond to the provided credit card remote control.
12Polk Customer Service