ASSEMBLING LEGS TO BASE
Mechanically lift the machine using a forklift and lifting straps to support the machine. The four steel legs should be attached to each corner of the base using sixteen
ASSEMBLING OVERARM ELEVATING HANDLE
1.Insert shear pin (A) Fig. 5, into the hole in elevating shaft (B). Using a hammer, tap this pin in to place as show in Fig. 5.
2.Line up the slots in elevating handle (C) Fig. 5, with shear pin (A) and place handle on shaft (B) making certain the roll pin is engaged in the slots.
3.Fasten elevating handle (C) Fig. 6, to shaft (B) with a
(E).
A
D
B C
Fig. 4A
AB C
Fig. 4B
C
A
B Fig. 5
D
ASSEMBLING CUTTINGHEAD TO TRACK ARM
1.Raise the track arm assembly (A) Fig. 7, by turning overarm elevating handle (F) Fig. 2.
2.Remove packing material from around cuttinghead assembly (B) Fig. 7.
C
B
E
D
Fig. 6
C
F
E
D
A
B
Fig. 7
10
