ADJUSTING TABLE BRACKETS PARALLEL TO TRACK ARM
To perform accurate work, the track arm must be parallel to the table top brackets at both the front and rear of the machine. To check if the alignment is correct, proceed as follows:
1.Loosen yoke clamp locking lever (A) Fig. 16, pull up yoke clamp index knob (B) and rotate yoke (C) to the out rip position shown in Fig. 17. Tighten yoke clamp locking lever (A).
B
A
C
Fig. 16
B
AC
Fig. 17
2.Place wrench (D) Fig. 18, on flats of arbor and loosen arbor nut (E) using wrench (F).
D
E
F
Fig. 18
13
