ASSEMBLING TABLE BOARDS
1.Place main table board (A) Fig. 27, on the table mounting brackets making sure that the two roll pins in the table mounting brackets fit into the two holes in bottom of main table board (A). Fasten table in place, place a 1/4" flat washer onto a
2.Place the remaining loose boards (C) Fig. 28 and fence (D) on the table mounting brackets, and tighten the two table clamp rod knobs (E). Fence (D) can be repositioned as required.
ASSEMBLING SAW BLADE AND BLADE GUARD
USE ONLY 12” BLADES RATED FOR AT LEAST 3450 RPM.
1.
DISCONNECT MACHINE FROM
POWER SOURCE.
2.Remove arbor nut (A) Fig. 29, and outside blade flange (B). NOTE: THE BLADE IS TO BE ASSEMBLED
BETWEEN THE TWO BLADE FLANGES (B) AND (C) WITH THE RECESSED SIDES OF THE FLANGES AGAINST THE SAW BLADE.
3.Assemble the saw blade (D) Fig. 30, between the two blade flanges making sure the teeth of the saw blade are pointing down at the front.
4.Assemble arbor nut (A) Fig. 30 to shaft and tighten with wrench (E) Fig. 30, while keeping arbor shaft from turning with other wrench (F).
A
B
B
Fig. 27
DC
E
E
Fig. 28
C
B
A
Fig. 29
D
A
E
F
Fig. 30
16
