INSTALLING AND REMOVING THE BIT
USING SPINDLE LOCK ACTUATOR (892)
Disconnect tool from power source.
NOTE: The spindle lock actuator will not engage when the tool is turned on. Turn tool off when using spindle lock actuator.
1.Turn the router upside down on its motor cap.
2.Push down and rotate the spindle lock actuator (A) Fig. 3 into place.
3.Open the clamp (B) Fig. 4.
4.Press the lever (C) Fig. 4 and push the base down as far as it can go.
5.Release lever (C).
6.Push the spindle lock actuator
(A)Fig. 3 while turning the chuck (D) Fig. 5 to engage spindle lock.
7.Clean and insert the shank of the bit into the collet (loosening the collet if necessary) until the shank bottoms, then back it out approximately 1/16".
8.Ensure spindle lock is engaged.
9.Place the wrench on the collet nut (E) Fig. 5 and turn CLOCKWISE to tighten. Tighten firmly.
10.Push down and rotate the spindle lock actuator back out, disengaging the spindle lock.
Failure to disengage the spindle lock could result in injury or damage
to the tool.
11.To remove the bit, reverse the procedure.
A
Fig. 3
B
C
Fig. 4
D
E
A
Fig. 5
10
