How to Use Your Unit
How to Stop:
1.See the engine manufacturer's manual for the procedure to safely shut down the gasoline engine. Turning the gasoline engine off will turn off the air compressor as well.
Before First Start-up
Serious damage may result if the following
instructions are not closely followed. This procedure is required when:
1.Before the air compressor is used for the first time.
2.When the unloader valve is replaced.
3.When a complete compressor pump is replaced.
The procedure:
1.To prevent pressure from building up in the air tanks during this
2.Open the pressure regulator. Pull regulator knob and rotate clockwise until it stops.
3.Start engine. See engine manual supplied by engine manufacturer for correct procedure.
The air compressor is top heavy. Make sure the unit is in
a stable position and will not tip before pulling Open the starter cord of the engine.
4.Make sure the unloader valve is in the “Open” position to prevent tank pressure buildup.
5.Run the air compressor for 30 minutes to seat the rings and lubricate all the internal surfaces. Make sure there is no pressure build up in the tank by observing the reading on the tank pressure gauge.
6.Place unloader valve in the “Closed” position as shown.
7.Close the pressure regulator. Rotate the regulator knob
NOTE: When the air tank is pressurized, the tank pres- |
|
sure gauge will indicate the pressure available in the air |
|
tank and the gasoline engine will reduce its speed to |
|
idle and keep running. The pressurization of the air tank | Closed |
will be adjusted automatically by the "reset" and "blow | |
off" setting of the unloader valve. When the pressure in |
|
the air tank drops to the "reset" value, the gasoline engine will increase its rpm to operate the compressor and pressurize the tanks. When the pressure in the air tank increases to the "blow off" value, the engine rpm will drop to idle.
NOTE: Consult the engine manufacturer's manual for the proper engine
D26998 |
