Porter-Cable CPLC7060V instruction manual With the filter removed. Refer to

PROBLEM	CAUSE	CORRECTION
Knocking Noise.	Possible defect in safe-	Operate safety valve manually by
	ty valve.	pulling on ring. If valve still leaks,
		it should be replaced.
	Defective check valve.	Remove and clean, or replace.
	Loose pulley	Tighten pulley set screw,
		70-80 in.-lbs.
	Loose flywheel	Tighten flywheel screw,
		15-20 ft.-lbs.
	Compressor mounting	Tighten mounting screws,
	screws loose	15-20 ft.-lbs.
	Loose belt	Loosen wingnut and then tighten
		wingnut until it contacts the wash-
		er, plus one turn.
	Carbon build-up in	Have checked by a Trained
	pump	Service Technician.
	Belt to tight	Loosen wingnut and then tighten
		wingnut until it contacts the wash-
		er, plus one turn.
Compressor is not	Prolonged excessive use	Decrease amount of air usage.
supplying enough	of air.
air to operate	Compressor is not large	Check the accessory air require-
accessories.
	enough for air require-	ment. If it is higher than the
	ment.	SCFM or pressure supplied by
		your air compressor, you need a
		larger compressor.
	Hole in hose.	Check and replace if required.
	Check valve restricted.	Remove and clean, or replace.
	Air leaks.	Tighten fittings.
	Restricted air intake filter	Clean or replace air intake filter.
		Do not operate the air compressor
		with the filter removed. Refer to
		the “Air Filter” paragraph in the
		“Maintenance “ section
	Loose belt.	Loosen wingnut and then tighten
		wingnut until it contacts the wash-
		er, plus one turn.

D23269 20 - ENG