ASSEMBLY
Tools Required for Assembly
1 - 9/16” socket or open end wrench Electric drill
Unpacking
1.Remove all packaging.
It may be necessary to brace or support one side of the outfit when removing the pallet because the air
compressor will have a tendency to tip.
2.Remove and discard the (4) screws and washers holding the compressor to the pallet.
3.With the help of another person carefully remove air compressor from pallet and place on a level surface.
To Add Oil To Pump
Compressors are shipped without oil. A small amount of oil may be present in the pump upon receipt of the
air compressor. This is due to plant testing and does not mean the pump contains oil. Do not attempt to operate this air compressor without first adding oil to the crankcase. Serious damage can result from even limited operation unless filled with oil and broken in cor- rectly. Make sure to closely follow initial
deposits on critical components, thus reducing performance and compressor life. Use air compressor oil only.
NOTE: Use an air compressor oil such as
1.Place unit on a level surface.
2.Remove oil fill plug (A) and slowly add a com- pressor oil until it is even with the top of the oil fill hole. NOTE: Do not allow oil to be lower than 3/8" (6 threads) from the top at any time. When filling the crankcase, the oil flows very slowly into the pump. If the oil is added too quickly, it will overflow and appear to be full. NOTE: Crankcase oil capacity is approximate- ly 16 fluid ounces.
3.Replace oil fill plug.
A
7 - ENG | D23269 |
