Porter-Cable T525, CTE300, BS600 Troubleshooting Guide, Problem, Cause, Correction

TROUBLESHOOTING GUIDE

PROBLEM		CAUSE		CORRECTION
Engine will not start	1.	Low on fuel or oil.	1.	Add fuel or oil.
	2.	Ignition switch in "Off" position.	2.	Turn to "ON" position
	3.	Faulty spark plug.	3.	Replace spark plug.
	4.	Choke in wrong position.	4.	Adjust choke accordingly.
	5.	Fuel shut-off valve in closed	5.	Open fuel shut-off valve.
		position.
	6.	Unit loaded during start-up.	6.	Remove load from unit.
	7.	Spark plug wire loose.	7.	Attach wire to spark plug.
No electrical output	1.	Faulty receptacle.	1.	Have Service Center replace.
	2.	Circuit breaker kicked out.	2.	Depress and reset.
	3.	Defective capacitor.	3.	Have Service Center replace
				capacitor.
	4.	Faulty power cord.	4.	Repair or replace cord.
	5.	GFCI switch breaker kicked out	5.	Depress and reset
		(BS600)
Repeated circuit breaker tripping	1.	Overload	1.	Reduce load.
	2.	Faulty cords or equipment.	2.	Check for damaged, bare, or
				frayed wires on equipment.
				Replace.
Generator overheating	1.	Generator overloaded.	1.	Reduce load.
	2.	Insufficient ventilation.	2.	Move to adequate supply of
				fresh air.

19 — ENG