Porter-Cable H1000IS-W instruction manual Connecting Procedure for Raising or Suspending Generator

4.Voltage sensitive equipment should be the last equipment connected to the generator. Plug voltage sensitive appliances such at TV's, VCR's, micro- waves, ovens, computers, and cordless telephones into a UL listed voltage surge protector, then connect the UL listed voltage surge protector to the generator.

Failure to connect and operate equipment in this sequence can cause damage to equipment and will void the warranty

on your generator.

Follow the wattage calculation table in the Wattage Calculation section of this manual. Overloading the generator will cause power fluctuations and can damage equipment and appliances.

Porter-Cable Corporation will only be responsible for damage to customer's equipment when the generator is determined to be defective. This determination will only be made by an authorized representative of Porter-Cable Corporation and this decision will be final. Porter-Cable Corporation reserves the right to inspect the electrical connections at the customer's site of operation and test the generator for proper operation before any determination of liability is made. Failure to maintain the equipment or wiring for inspection will void any claim for damages by the customer. Porter-Cable Corporation will not be responsible for equipment damaged as a result of voltage surges, improper operation or improper installation of the generator.

CONNECTING PROCEDURE FOR RAISING OR SUSPENDING GENERATOR

Failure to properly connect lifting cables, chains, or straps can cause properly damage, serious injury or death, and void the

manufacturer’s warranty.

Always use cables, chains, or straps rated at 2000 lbs. working load or more to raise or suspend generator.

Never operate generator while suspended. This could cause property damage, serious injury or death.

DO NOT suspend objects other than generator from skyhook.

1.Route cable, chain, or strap through lift ring as shown. ALWAYS use lift

ring when raising or suspending generator.

NOTE: Make sure the generator is in a level position before raising or suspending to prevent damage.

19- ENG A01296