Porter-Cable C2004, N034163 instruction manual Motor Overload Protector not shown, How to Stop

Models: C2004 N034163

1 64
Download 64 pages 29.29 Kb
Page 11
Image 11

Drain Valve: The drain valve is located at the base of the

 

 

 

 

air tank and is used to drain condensation at the end of

 

 

each use.

 

 

Drain

Check Valve: When the air compressor is operating, the

 

 

Valve

check valve is "open", allowing compressed air to enter

 

 

 

the air tank. When the air compressor reaches "cut-out"

 

pressure, the check valve "closes", allowing air

 

 

 

pressure to remain inside the air tank.

 

 

 

Motor Overload Protector (not shown): The

 

 

 

motor has a thermal overload protector. If the motor

 

 

 

overheats for any reason, the overload protector

Check Valve

 

will shut off the motor. The motor must be allowed

 

 

 

 

to cool down before restarting. To restart:

 

 

 

1.Set the On/Off lever to "Off" and unplug unit.

2.Allow the motor to cool.

3.Plug the power cord into the correct branch circuit receptacle.

4.Set the Auto/Off lever to "On" position.

Quick-Connect Body: The quick connect body accepts industrial quick connect plugs. The two quick connect bodies allow the use of two tools at the same time.

How to Use Your Unit

How to Stop

1.Set the On/Off switch to "Off".

2.Unplug unit when not in use.

Before Starting

Do not operate this unit until you read this instruction manual for safety, operation and maintenance instructions.

Before Each Start-Up

1.Set the On/Off switch to "Off".

2.Plug the power cord into the correct branch circuit receptacle. (Refer to Voltage and Circuit Protection paragraph in the Installation section of this manual.)

3.Turn the regulator knob counterclockwise to set the outlet pressure to zero.

4.Attach hose and accessories.

Risk of unsafe operation. Firmly grasp air hose in hand when installing or disconnecting to prevent hose whip.

Risk of unsafe operation. Do not use damaged or worn

accessories.

NOTE: The hose or accessory will require a quick connect plug if the air outlet is equipped with a quick connect socket.

Risk of Bursting. Too much air pressure causes a hazardous risk of bursting. Check the manufacturer’s maximum pressure rating for air tools and accessories. The regulator outlet pressure must never exceed the maximum pressure rating.

Risk of property damage. Compressed air from the unit may contain water­ condensation and oil mist. Do not spray unfil­tered­ air at an item that could be damaged by moisture. Some air tools and accessories may require filtered air. Read the instruc­tions­ for the air tools and accessories.

11 - ENG

Page 11
Image 11
Porter-Cable C2004, N034163 Motor Overload Protector not shown, How to Stop, Before Starting Before Each Start-Up