Risk of Bursting. Water will condense in the air tank. If not drained, water will corrode and weaken the air tank causing a risk of air tank rupture.
Risk of Property Damage. Drain water from air tank may contain oil and rust which can cause stains.
1.Set the On/Off switch to "Off".
2.Turn the regulator knob counterclockwise to set the outlet pressure to zero.
3.Remove the air tool or accessory.
4.Place a suitable container under the drain valve to catch discharge.
5.Grasp lever on drain valve.
6.Slowly rotate lever to gradually bleed air from air tank.
7.When air tank pressure gauge reads 10 psi, rotate valve to the fully open position.
8.Close drain valve when finished.
NOTE: If drain valve is plugged, release all air pressure. The valve can then be removed, cleaned, the reinstalled.
SERVICE AND ADJUSTMENTS
ALL MAINTENANCE AND REPAIR OPERATIONS NOT LISTED MUST BE PERFORMED BY TRAINED SERVICE TECHNICIAN.
Risk of Unsafe Operation. Unit cycles automatically when power is on. When servicing, you may be exposed to voltage sources, com- pressed air, or moving parts. Before servicing unit unplug or disconnect electrical supply to the air compressor, bleed tank of pressure, and allow the air compressor to cool.
To Replace Regulator
1.Release all air pressure from air tank. See To Drain Tank in the Maintenance section.
2.Unplug unit.
3.Remove the console cover.
4.Using an adjustable wrench remove the safety valve from the regulator mani- fold.
Console Cover
Safety
Valve
5.Remove the hose by removing the hose clamp. NOTE: The hose clamp is not reusable. You must purchase a new hose clamp, see Replacement Parts in the Service section or purchase a standard hose clamp at a local hardware store.
13 - ENG
