Porter-Cable PCL180L Maintenance, Troubleshooting, Problem, Possible Cause, Possible Solution

90546221 pc1800l pcl180l 1/5/09 12:34 PM Page 10

To replace the bulb:

1.Unscrew the lens holder (2).

2.Turn the bulb until the triangular cutout on the rim of the bulb lines up with the triangular notch shown in figure E.

3.Pull the bulb out and insert a new bulb by lining up the triangular notch and the triangular cutout. Turn the bulb a half turn to lock in place.

4.Reinstall the lens holder

NOTE: Do not look directly into the light beam.

E

	TROUBLESHOOTING
PROBLEM	POSSIBLE CAUSE	POSSIBLE SOLUTION
• Light will not illuminate.	• Battery not installed properly.	• Check battery
		installation.
	• Battery not charged.	• Check battery
		charging requirements.
	• Light bulb needs replacing.	• Replace bulb as
		outlined in this manual.

•Battery will not charge. • Battery not inserted into charger. • Insert battery into charger until LED appears.

• Charger not plugged in.	• Plug charger into a
	working outlet. Refer to
	“Important Charging
	Notes” for more details.

For assistance with your product, visit our website at www.portercable.com for a list of service centers, or call the Porter-Cable Customer Care Center at (888)

848-5175.

THE RBRC™ SEAL

The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the NI-CD battery (or battery pack) indicates that the costs to recycle the battery (or battery pack) at the end of its useful life have already been paid by Porter-Cable.

RBRC™ in cooperation with Porter-Cable and other battery users, has established programs in the United States to facilitate the collection of spent NI-CD batteries. Help protect our environment and conserve natural resources by returning the spent NI-CD battery to an authorized Porter-Cable service center or to your local retailer for recycling. You may also contact your local recycling center for information on where to drop off the spent battery.

RBRC™ is a registered trademark of the Rechargeable Battery Recycling Corporation.

MAINTENANCE

Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid.

10