window are designated for VGA port and COM port power supply function. Please consult your dealer for technical support on setup of these jumpers. Please note that only those qualified technicians Jumpers may adjust in the service
window with information from Posiflex and the contents in the service window may change without notice as time develops.
Service Window Lock Screw
SIDE MOUNT UPGRADE KIT (OPTION)
Remove the 2 screws circled in last picture above to remove the cover for side mount upgrade kit. Take out the cable inside this cover and connect it to connector inside the side mount upgrade kit like SD400T as circled in the right picture. Gently arrange the excessive length of this cable back in the hole and
the cover if there is chance to have the side mount kit removed in the future.
REAR TOP MOUNT UPGRADE KIT (OPTION)
To mount the rear top mount upgrade kit like
please apply carefully the 2 small fixation shoulder screws that come along with
to the back of KS series at the screw hole triangle marked in the right picture. However please do not screw them to the bottom but at a position that is
about 1 turn loose from the bottom. Similarly please loosen the screws by 1 turn for some models with these 2 screws preinstalled. Arrange the interface cable of the rear top mount upgrade kit to go into the first groove to the right of the left shoulder screw on back of main unit as in the above right picture. For gen 6 super slim base models, please stick the 2 attached cable clips at arrowed positions in the picture for cable routing when later joining the main unit to gen 6 base. Hook the rear bracket of the upgrade kit onto the shoulder screws. Slide down the upgrade kit and gently tighten the shoulder screws. Do not overdo the tightening or unrecoverable thread damage will occur. Remember to enable the +5 V DC supply in the COM port of the main unit for the upgrade kit if the serial interface model is used. The power supply in the I/O port must be disabled if it is no longer to support these intended devices otherwise any damage or loss caused consequently shall be out of product warranty! However, if the customer display used is the USB interface model,
Part 11
