when disconnecting any connector. Failure to do this could damage the cable and jack that is considered as an artificial destruction. Damages due to incorrect disconnection operation are not covered by product warranty!
SEPARATING MAIN UNIT
In order to settle the touch terminal properly in a point of sale system, all the cable connections have to be routed through its base. Therefore, please observe the procedures from A to C below to separate the main unit from the base stand assembly after all cables in cable cover disconnected.
|
|
| C | Step A: Prepare a soft clean flat surface, such |
|
|
| ||
|
|
| B | as a piece of cloth on the desk to seat |
|
|
| A | the front surface of main unit after |
|
|
|
| being adjusted to most horizontal |
w/ Gen 5 base |
|
| ||
| position | |||
|
|
|
| |
|
|
|
|
w/ Gen 6 base
C | Step B: Press the Lock/Release button for | |
B | main unit detach and meantime ... | |
Step C: Slide the base stand assembly to left to | ||
A | ||
| separate the main unit from base stand |
OPENING SLIM BASE BOTTOM
Gen 5 base
Take the adjustable stand assembly of the gen 5 slim base and turn it up side down to show the bottom of the base. Remove the bottom plate fixing screws in center of rubber feet to remove the bottom plate. For maintenance operation that there are already some cable connections, please release the cables from the 2 plastic cable holders and have all cables to pass through the cable passage in bottom plate as in the left picture.
INSTALLING UPS BATTERY (OPTION)
The optional UPS battery is delivered in the carton if it is ordered. For slim base model, please refer to the left picture and place the UPS battery in the cavity in base with the rectangular marked end first. Route the battery
connection cable together with all other external connection cables through the arrow marked passage to the battery connector on the main unit. If the optional cable clip is available, insert it into a hole marked in circle in the picture and use it to hold the
Part 8