INSTALLATION GUIDES
CAUTION: Before any installation or cable connection to the set, please always make certain that the system is turned off and the external power source to the set is removed to prevent electric hazard! Never touch any metal pin in the connectors or circuits to avoid high voltage hazard or electrostatic discharge damage unless the operator is well grounded. Failure to do the above will void the product warranty!
OPENING CABLE COVER
Please follow steps A to C sequentially with reference to pictures below to remove the cable cover for Gen 5 slim base models and steps B and C for Gen 6 super slim base models.
B B
A
C
w/ Gen 5 base
C
w/ Gen 6 base
Step A: Push lock/release lever of the Gen 5 slim base for tilt angle adjust backward. (This operation is not required in Gen 6 super slim base)
Step B: Turn panel to most horizontal position
Step C: Pull at the removal hollow toward the user
Tips: 1. If there is trouble removing the cable cover, try
pressing the arrowed portion of cable cover in the rear view picture at right at the same time.
2. If there is still trouble removing the cable cover, don’t force open it. Consult your system administrator if it has been locked on purpose.
DISCONNECTING ALL CABLES
After removal of the cable cover, the I/O connector area will be accessible then. Please first note orientations of every existing cable connection and then disconnect every cable properly before separating the main unit from the adjustable stand assembly. Please note that the click lock spring has to be pressed down prior to pulling out the connector such as the LAN port or the CR port. Please also note that the fixing screws have to be loosened free prior to disconnection such as the LPT port or COM ports. Please always hold the connector head instead of pulling on the cable wire
Part 7