battery cable. The UPS battery will be held in place when the bottom plate is screwed back. As for gen 6 super slim base model, please remove the UPS battery bracket on bottom of the stand assembly instead of the bottom plate as in the right picture.
Please pay particular attention to the environment requirements for UPS battery in next chapter “USING THE TOUCH POS”.
Gen 6 base
BASE MOUNT UPGRADE KIT (OPTION)
On rear top edge of the gen 5 slim base stand assembly for desktop mount application, there is a rear connect cover as
marked in the right picture. It can be removed by pressing the center part down. Either a 2nd LCD display
panel option
LCD customer display option
Please note that for
Fit the joint base of
screws with washers to hold the joint tight as in the
picture at right. Then insert the cable into the base mount
device cable groove and cable holder on bottom plate and connect to the main unit through the base. For low profile
customer display
Remember to enable the +5 V DC supply in the COM port of the main unit for
Part 9