Part 11
the software system on HDD collapses, it is possible to restore the operating
system onto a physically intact HDD with use of the Recovery CD that comes
with the preloaded operating system. Please follow the instruction from your
system integrator for system / software restoration. Follow the instructions
below for operating system recovery only if your system integrator does not
advise otherwise.
For the Jiva TP/LT-5800G preloaded with Windows XP Pro or Windows
98 on HDD, Posiflex provides recovery CD delivered with the touch terminal
for the preloaded operating system. The System Integrator shall take care of
software restoration after OS recovered. A Posiflex supplied USB interface
CDROM drive will be required for such action. Other brand CDROM drive
may require its specific driver different from what supported in the recovery
CD. Please use the recovery CD in rescue operation only. Using it
otherwise may wipe out whatever stored in the HDD! All upgrade devices
drivers needed for manual installation in usual way are available in the
subfolder “\drivers” in OS recovered HDD and the latest versions of these
required drivers will be available on our web: http://www.posiflex.com.tw.
Now please follow instructions from your system integrator for
software recovery.
Please refer to the “System Protection” section in chapter “USING
THE TOUCH POS” for guidance on the Time-Machine-like system recovery.
OPERATING SYSTEM INSTALLATION This product is a highly professionalized equipment. The installation
of an OS into a machine without any preloaded OS could constitute major
difficulty for average user who either has barely limited technical knowledge
of this professionalized equipment or is insufficiently equipped with necessary
facilities to accomplish such a task. Therefore, installation of an OS into a
system without preloaded OS is highly discouraged. Posiflex shall not be
responsible for any technical support to questions arisen due to non-preloaded
OS.
IDE CABLE KIT (FOR JIVA 5800G) There are an IDE connector and a 4 pin power connector in the I/O
area of Jiva 5800G designed for software installation occasions. Please use the
optional IDE cable kit for such occasion to connect both data and power from
the main unit to the IDE device such as an internal type IDE interface CD
ROM drive. Please pay particular attention to each cable orientation in the
connection and fix if there is any grounding terminal for cable shielding to
suitable screw on metal casing. Remove every connection when the software
installation is done.