Part 17
Please be solemnly alerted that the system restore operation means the
irrecoverable erasement of existing data or system setup, it is strongly advised
to press “Esc” key to avoid such miserable damage if there is any doubt.
Pressing “F4” key at this screen will save the current status of the
whole system and the earlier saved status will be cleared at the same time.
Therefore, please do this save only when you know that your current system
status is “safe” and “clear”.
Pressing “F3” key at this screen will restore the last saved system
status. Please be aware that whatever data or any system change ever since last
“save” will be permanently lost by this restore operation. Therefore, do restore
only after you have made all the necessary data preservation!
Pressing “F2” key at this screen will restore your system back to the
“OS + application software” situation that your system integrator has put into
protection with technical help from Posiflex before they deliver you this POS
system with software solution. Please note that whatever data or any system
change you have made on this system will be lost by this action. Pressing “F2”
key will have no response if your system integrator did not do the protection or
if you have erased their effort by action in next paragraph.
Pressing the three key combination of “Ctrl” + “Alt” + “F1” will
restore your system right back to the “pure OS” status. Please never take this
action unless you know exactly what you are doing and what to do next! The
whole process may take quite a while.
TOP MOUNT CUSTOMER DISPLAY Please follow the instructions on the manual that comes along with
the top mount customer display PD302 when it is installed.
SERIAL PORTS – COM1/2/3/4 In Jiva TP/LT-5700G / Jiva TP/LT-5800G, there are 4 serial ports
available except those models using RS232 touch interface (Infra Red type
touch panel). All the serial ports can supply a +5 V DC through pin 9 after
proper jumper setting change. All 4 ports are standard RS232 serial ports as
status at delivery.
When a serial Modem is to be used in Jiva TP/LT-5700G or Jiva
TP/LT-5800G, it is most recommended to use COM2 or COM3 port for this
purpose. In this way any hardware resource conflict is eliminated and the
MODEM ring up function can be supported. For Infra Red type touch control
models (it uses RS232 interface), COM4 is occupied and covered. Please
never try to open the cover. Otherwise the product warranty is voided.