Part 7
Connect the 6 pole plug of CCBLA-238 to “CR” port and connect each 8 pole
plug to the connector marked “signal cable from POS Printer” at the rear of
one of the cash drawer. In this way, the Jiva series is capable of controlling
two cash drawers independently through software command.
ROUTING THE CABLES Place all the cables required for connections to the Jiva TP/LT-5700G
or Jiva TP/LT-5800G except those for special application purposes into the
cable passage. Insert one end of the cable passage cover under the adjacent
cover plate and screw on the two screws. Be sure not to damage any of the
cables during this operation.
Now, turn the adjustable stand assembly back to normal orientation
and arrange all cables to come out of the area for mounting main unit from the
bottom edge for ease of later operation.
PREPARING THE MAIN UNIT On the back of the main unit, there are 4 matching pegs and a service
window. Push open the service window in the direction as indicated in the
picture, one can find a button cell battery socket, two 1 x 2 (JP6, 9) and two 1
x 3 headers (JP11, 16) with 1 jumper each and two 2 x 3 header (JP13, 14)
with 2 jumpers each. Though it is possible that the contents in the service
window may change as time develops.
This battery socket accepts a 3 V button cell Lithium battery (CR2032)
CAUTION Risk Of Explosion If Battery Is Replaced By An Incorrect Type
Dispose Of Used Batteries According To The Instructions
Push
Open
To The
Right
Service
W
in
dow
4 Matching
Pegs
This End to Other Devices
Route Cables under the Cover
Fix this End of the Cover First
Connect this End to Main Unit