7.Carefully remove new chain from pack- age. Hold chain with the drive links as
shown.
Cutter
Tip of
Bar
Drivelink
CUTTERS MUST FACE IN
DIRECTION OF ROTATION
Cutters | Depth Gauge |
|
Drive Links
8.Place chain over sprocket, fitting the drive links in the sprocket.
9.Fit bottom of drive links between the teeth in the sprocket in the nose of the guide bar.
10.Fit chain drive links into bar groove.
11.Pull guide bar forward until chain is snug in guide bar groove. Ensure all drive links are in the bar groove.
12.Now, install bar clamp making sure the adjusting pin is positioned in the lower hole in the guide bar.
13.Install bar clamp nut and finger tighten only. Do not tighten any further at this point. Proceed to the CHAIN ADJUST- MENT section.
CHAIN ADJUSTMENT
See CHECK CHAIN TENSION in MAINTE- NANCE section.
CARBURETOR IDLE SPEED ADJUSTMENT
WARNING: Keep others away when making idle speed adjustments. The chain will be moving during most of this procedure. Wear your protective equipment and observe all safety precautions. After making adjust- ments, the chain must not move at idle speed. The carburetor has been carefully set at the factory. Adjustment to the idle speed may be necessary if you notice any of the following conditions:
SEngine will not idle when the throttle is re-
leased.
SThe chain moves at idle.
Make adjustments with the unit supported so the pruner is off the ground and the chain will not make contact with any object. Hold the unit by hand while running and making adjust- ments. Keep all parts of your body away from the chain and muffler.
To adjust idle speed:
Allow engine to idle. Adjust idle speed until en- gine runs without chain moving (idle too fast) or stalling (idle speed too slow).
S Turn idle speed screw clockwise to in- crease engine speed if engine stalls or dies.
S Turn idle speed screw counterclockwise to decrease engine speed if chain moves at idle.
WARNING: Recheck the idle speed after each adjustment. The chain must not move at idle speed to avoid serious injury to the operator or others.
Idle Speed Screw
Lower
Hole
Adjusting Pin
Guide Bar
Air Filter Cover
If you require further assistance or are unsure about performing this procedure, contact your authorized service dealer or call
18
