Model Number, Snow Thrower | Poulan 421064 instruction

IMPORTANT MANUAL

Do Not Throw Away

OWNER'S MANUAL

MODEL NUMBER:

PP10530ES

SNOW THROWER

WARNING:

Read the Owner's Manual and follow all Warnings and Safety Instructions. Failure to do so can result in serious injury.

Always Wear Eye Protection During Operation

421064 07.03.08 CL

Printed in U.S.A.

Image 1

Poulan 421064 owner manual Model Number, Snow Thrower

Contents

Snow Thrower Model Number Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents Parts Packed Separately in Carton HOW to SET UP Your Snow Thrower Assembly / PRE-OPERATIONRemove Snow Thrower from Carton Unfold Upper Handle Install Auger Control ROD See Figs Install Traction Drive Control ROD See Figs Install Chute Deflector Remote Control See Figs Install Discharge Chute / Chute Rotater Head See FigCheck Tire Pressure Know Your Snow Thrower OperationPrimer Ignition KEY Recoil auxiliary starter handle used for starting engine Meets A.N.S.I. Safety Requirements Stopping HOW to USE Your Snow Thrower Power Steering Operation See Fig Using the CLEAN-OUT Tool See FigTo Throw Snow See Fig To Move Forward and Backward See Fig Before Starting the Engine To Adjust Skid Plates See FigCheck Engine OIL Level See Fig ADD Gasoline See Fig To Start Engine Snow Throwing TipsBefore Stopping If Recoil Starter has Frozen General Recommendations MaintenanceBefore Each USE Lubrication Snow Thrower CleaningEngine To Adjust Snow Thrower Height Service and AdjustmentsChute Deflector Shear Bolts See Fig To Replace Belts See Fig Other Storage Troubleshooting Exploded KEY Part Description Scrapper BAR Auger HousingAuger Bearing Bearing Plug Auger Assembly 30 RH Auger Assembly 30 LH Chute Weldment Deflector Control AssemblyDeflector Weldment Deflector Seal Rotator Head LEVER/CABLE Rotator AssemblyRotator Pivot Bracket Pulley Pivot Loop Handle LH 419798X479 Knob RED SpacerHandle Knob Washer 3/8 Traction ROD Assembly Impeller ROD AssemblyShifter ROD TOP Shifter ROD Bottom Lower Handle Wire HarnessPivot Support Weldment Console Panel Repair Parts Snow Thrower Model PP10530ES Drive END Plate 43 420900 Drive Plate AssemblyWasher Control ARM 01.03.002-A LH358SA-159628A KEY Part Description Tecumseh Engine Model417014X428 Engine Mount Plate Traction Belt Belt CoverImpeller Belt Wheel Driver Retainer Ring CoverWheel Lobe Clutch Slide Cable Bracket RH Cable Bracket LH 35062 Safety Ignition KEY DECAL, Danger 181037 Service Notes HOP Limited Warranty