Cover, Wheel Driver Retainer Ring, Wheel Lobe | Poulan 421064

REPAIR PARTS SNOW THROWER - MODEL PP10530ES (96192001802)

WHEELS

														2
								17					3	2
						20		17		23		4	3	1
						20			19		6	5
						16					6	5
				17	18	16				22	7
						15	18			22	7
						15	18			9	8
				16		24				10
				20		23		21		11
				19		22
				19						12
				21						12
										14
								14 13		13
						11		14 13
					10			12
2				8	9
2				7
	3	4	5	6
2	1 01.15.001-A
				KEY	PART				DESCRIPTION
				NO.	NO.				DESCRIPTION
				1	405161				COVER
				2	184471				SHOULDER SCREW

312000045 RETAINER RING

4192126 WHEEL DRIVER

5182466 RETAINER RING

6	187622	WHEEL LOBE
7	194941	CLUTCH SLIDE
8	179139	SPRING
9	189282	SQUARE KEY
10	194940	AXLE LOBE
11	174697	THRUST WASHER

12193506X479 STEERING YOKE

13179148X479 STEERING BRACKET

1417490508 SCREW 5/16−18 X .50

15194943X008 PIVOT BRACKET

16194944X008 BELLCRANK

17181847 BELLCRANK PIN

1817600406 SCREW 1/4−20 X .375

19405077 STEERING LINK

20	700279	RETAINER
21	85179	RETAINER
22	193885	SPRING
23	182015	LEVER PIN
24	194939X008	PIVOT BRACKET

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty.

35

Image 35

Poulan 421064 Cover, Wheel Driver Retainer Ring, Wheel Lobe, Clutch Slide, Axle Lobe, 13 179148X479 Steering Bracket

Contents

Snow Thrower Model Number Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents Parts Packed Separately in Carton Unfold Upper Handle Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Remove Snow Thrower from Carton Install Auger Control ROD See Figs Install Traction Drive Control ROD See Figs Check Tire Pressure Install Discharge Chute / Chute Rotater Head See FigInstall Chute Deflector Remote Control See Figs Ignition KEY OperationKnow Your Snow Thrower Primer Recoil auxiliary starter handle used for starting engine Meets A.N.S.I. Safety Requirements Stopping HOW to USE Your Snow Thrower To Move Forward and Backward See Fig Using the CLEAN-OUT Tool See FigPower Steering Operation See Fig To Throw Snow See Fig ADD Gasoline See Fig To Adjust Skid Plates See FigBefore Starting the Engine Check Engine OIL Level See Fig If Recoil Starter has Frozen Snow Throwing TipsTo Start Engine Before Stopping Lubrication MaintenanceGeneral Recommendations Before Each USE Engine CleaningSnow Thrower Shear Bolts See Fig Service and AdjustmentsTo Adjust Snow Thrower Height Chute Deflector To Replace Belts See Fig Other Storage Troubleshooting Exploded KEY Part Description Bearing Plug Auger HousingScrapper BAR Auger Bearing Auger Assembly 30 RH Auger Assembly 30 LH Deflector Seal Deflector Control AssemblyChute Weldment Deflector Weldment Pulley Pivot LEVER/CABLE Rotator AssemblyRotator Head Rotator Pivot Bracket Loop Handle LH 419798X479 Washer 3/8 SpacerKnob RED Handle Knob Shifter ROD Bottom Impeller ROD AssemblyTraction ROD Assembly Shifter ROD TOP Console Panel Wire HarnessLower Handle Pivot Support Weldment Repair Parts Snow Thrower Model PP10530ES Drive Control ARM 43 420900 Drive Plate AssemblyEND Plate Washer 01.03.002-A 417014X428 Engine Mount Plate KEY Part Description Tecumseh Engine ModelLH358SA-159628A Impeller Belt Belt CoverTraction Belt Clutch Slide CoverWheel Driver Retainer Ring Wheel Lobe Cable Bracket RH Cable Bracket LH 35062 Safety Ignition KEY DECAL, Danger 181037 Service Notes HOP Limited Warranty