Belt Cover, Traction Belt, Impeller Belt

REPAIR PARTS SNOW THROWER - MODEL PP10530ES (96192001802)

CHASSIS / ENGINE / PULLEYS

	KEY	PART	DESCRIPTION
	NO.	NO.	DESCRIPTION
2	1	192213	BELT COVER
2	2	179157	IMPELLER PULLEY
	3	419744	TRACTION BELT
	4	408007	IMPELLER BELT

401.04.019-A

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty.

Page 34

Image 34

Poulan 421064 owner manual Belt Cover, Traction Belt, Impeller Belt

Contents

Model Number Snow Thrower Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents Parts Packed Separately in Carton Remove Snow Thrower from Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Unfold Upper Handle Install Traction Drive Control ROD See Figs Install Auger Control ROD See Figs Install Chute Deflector Remote Control See Figs Install Discharge Chute / Chute Rotater Head See FigCheck Tire Pressure Primer OperationKnow Your Snow Thrower Ignition KEY Meets A.N.S.I. Safety Requirements Recoil auxiliary starter handle used for starting engine HOW to USE Your Snow Thrower Stopping To Throw Snow See Fig Using the CLEAN-OUT Tool See FigPower Steering Operation See Fig To Move Forward and Backward See Fig Check Engine OIL Level See Fig To Adjust Skid Plates See FigBefore Starting the Engine ADD Gasoline See Fig Before Stopping Snow Throwing TipsTo Start Engine If Recoil Starter has Frozen Before Each USE MaintenanceGeneral Recommendations Lubrication Snow Thrower CleaningEngine Chute Deflector Service and AdjustmentsTo Adjust Snow Thrower Height Shear Bolts See Fig To Replace Belts See Fig Storage Other Troubleshooting Exploded KEY Part Description Auger Bearing Auger HousingScrapper BAR Bearing Plug Auger Assembly 30 LH Auger Assembly 30 RH Deflector Weldment Deflector Control AssemblyChute Weldment Deflector Seal Rotator Pivot Bracket LEVER/CABLE Rotator AssemblyRotator Head Pulley Pivot 419798X479 Loop Handle LH Handle Knob SpacerKnob RED Washer 3/8 Shifter ROD TOP Impeller ROD AssemblyTraction ROD Assembly Shifter ROD Bottom Pivot Support Weldment Wire HarnessLower Handle Console Panel Repair Parts Snow Thrower Model PP10530ES Drive Washer 43 420900 Drive Plate AssemblyEND Plate Control ARM 01.03.002-A LH358SA-159628A KEY Part Description Tecumseh Engine Model417014X428 Engine Mount Plate Traction Belt Belt CoverImpeller Belt Wheel Lobe CoverWheel Driver Retainer Ring Clutch Slide Cable Bracket LH Cable Bracket RH Safety Ignition KEY 35062 181037 DECAL, Danger Service Notes Limited Warranty HOP

KEY

BELT COVER

TRACTION BELT

IMPELLER BELT