419798X479, Loop Handle LH | Poulan 421064 instruction

REPAIR PARTS SNOW THROWER - MODEL PP10530ES (96192001802)

HANDLES

5 5

	KEY	PART	DESCRIPTION
3	NO.	NO.
	1	419798X479	LOOP HANDLE LH

2419799X479 LOOP HANDLE RH

374780524 SCREW 5/16−18 X 1.50

4	74780528	SCREW 5/16−18 X 1.75
5	751153	NUT 5/16−18

01.08.004-A

		KEY	PART	DESCRIPTION
		NO.	NO.	DESCRIPTION
		1	412675X004	INTERLOCK SPRING
		3 2	414572	INTERLOCK CAM
	2	3	178831	TORSION SPRING
5	2	4	169675	RETAINER
5		5	17060410	SCREW 1/4−20 X .625
		5	17060410	SCREW 1/4−20 X .625
		6	421252	INTERLOCK STOP
	1
	6	01.08.007-B

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty.

Page 26

Image 26

Poulan 421064 owner manual 419798X479, Loop Handle LH

Contents

Model Number Snow Thrower Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents Parts Packed Separately in Carton Remove Snow Thrower from Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Unfold Upper Handle Install Traction Drive Control ROD See Figs Install Auger Control ROD See Figs Check Tire Pressure Install Discharge Chute / Chute Rotater Head See FigInstall Chute Deflector Remote Control See Figs Primer OperationKnow Your Snow Thrower Ignition KEY Meets A.N.S.I. Safety Requirements Recoil auxiliary starter handle used for starting engine HOW to USE Your Snow Thrower Stopping To Throw Snow See Fig Using the CLEAN-OUT Tool See FigPower Steering Operation See Fig To Move Forward and Backward See Fig Check Engine OIL Level See Fig To Adjust Skid Plates See FigBefore Starting the Engine ADD Gasoline See Fig Before Stopping Snow Throwing TipsTo Start Engine If Recoil Starter has Frozen Before Each USE MaintenanceGeneral Recommendations Lubrication Engine CleaningSnow Thrower Chute Deflector Service and AdjustmentsTo Adjust Snow Thrower Height Shear Bolts See Fig To Replace Belts See Fig Storage Other Troubleshooting Exploded KEY Part Description Auger Bearing Auger HousingScrapper BAR Bearing Plug Auger Assembly 30 LH Auger Assembly 30 RH Deflector Weldment Deflector Control AssemblyChute Weldment Deflector Seal Rotator Pivot Bracket LEVER/CABLE Rotator AssemblyRotator Head Pulley Pivot 419798X479 Loop Handle LH Handle Knob SpacerKnob RED Washer 3/8 Shifter ROD TOP Impeller ROD AssemblyTraction ROD Assembly Shifter ROD Bottom Pivot Support Weldment Wire HarnessLower Handle Console Panel Repair Parts Snow Thrower Model PP10530ES Drive Washer 43 420900 Drive Plate AssemblyEND Plate Control ARM 01.03.002-A 417014X428 Engine Mount Plate KEY Part Description Tecumseh Engine ModelLH358SA-159628A Impeller Belt Belt CoverTraction Belt Wheel Lobe CoverWheel Driver Retainer Ring Clutch Slide Cable Bracket LH Cable Bracket RH Safety Ignition KEY 35062 181037 DECAL, Danger Service Notes Limited Warranty HOP

REPAIR PARTS SNOW THROWER - MODEL PP10530ES (96192001802)

HANDLES

KEY

419798X479

LOOP HANDLE LH

KEY

INTERLOCK STOP